Note : You can only use very recent versions of Windows 10 Notepad to edit the file as it uses Linux convention for new line characters, older versions will show Linux files without linefeeds. Edit the file config.txt located in the root of the SD card and add the following line at the end of the file (if it is not already there), then save the file.Put your SD card in a card reader and access it on a PC or Mac.The newer OpenElec and LibreELEC versions end support for LIRC, therefore the remote is configured using the newer GPIO IR kernel driver method. OpenElec 8.0.0 and later, LibreELEC 8.2.0 and later The configuration procedure below will assign the following Kodi functions to the keys.įor the older remote without the color keys : If you own a Logitech Harmony remote you can follow these instruction instead : Using Logitech Harmony Remotes with the RemotePi BoardĬonfigure your mediacenter installation for the remote To use the power button of this remote with the RemotePi Board just enter the learning mode on the RemotePi board and press the power button to configure the RemotePi Board to use this button to toggle power. The remote uses the RC6 infrared protocol which is supported by the RemotePi Board, LIRC and the Linux IR kernel driver. ![]() Two AAA batteries (not included) are required. This infrared remote control is a standard replacement remote control for DVD / Blu-Ray players - It works well with the RemotePi Board and Kodi-based mediacenter installations.
0 Comments
Leave a Reply. |